150 watt high pressure flood light wiring diagram150 watt high pressure flood light

150 watt high pressure flood light specification:
Die-casting aluminum MH/HPS floodlight fixtures
CE IP65 E27/R7S lampholder MH/HPS/HID Max 150W.
Model No.: NF104
Material: Die-casting aluminium
Cover: Tempered glass
Reflector: Pure aluminum 0.7mm
Lampholder: E27 or R7S
IP rating: IP65
Watt: HID Max 150W
Others: Seal ring Inner gear plate 1.0mm
Included: Ignitor, Capacitor,150 watt HPS Ballast,bulb and flood lights

150 watt HPS flood light Suit for single 150W MH-T/HPS-T lamp, fabricated pedestal with a base plate,operation on 240V, 50Hz.Luminaire made of die-cast aluminum of low copper content to offer high corrosion resistance.
Optical system with imported aluminum sheets, covered with heat resistant toughened glass.
Continuous rubber gasket to ensure adequate sealing against ingress of moisture, dust, insects etc.
Mounting bracket to facilitate proper aiming of the luminaire at desired angle,Convenient and easy for installation and maintenance.
Finish : Pure polyester powder coated black.
These flood light are designed and developed as per the international quality norms and standards. To ensure the quality and flawlessness of our products, the range is thoroughly tested on various quality parameters.

Leave a Reply

Your email address will not be published. Required fields are marked *

Get an instant quote from our most experienced consultants